Alvarion Wi^2 AP CLI Especificaciones descargar pdf (Pagina 134)

108 Operation

Chapter 4 - System Configuration

After you have configured the radio settings, select Security under Radio G, set an

SSID to identify the wireless network service provided by each VAP you want to

use, and then click Apply to save your settings.

Before enabling the radio service for any VAP, first configure the WEP, WPA, and

802.1X security settings described in the following sections. After you have

finished configuring the security settings, return to the main Security page shown

below, start the required VAP interfaces by clicking the Enable checkbox, and

then click Apply.

Enable – Enables radio communications on the VAP interface. (Default: Disabled)

SSID – The name of the basic service set provided by a VAP interface. Clients that

want to connect to the network through the access point must set their SSID to

the same as that of an access point VAP interface. (Default: VAP_TEST_11A #

(0-3); Range: 1-32 characters)

4.6.2.2 Wired Equivalent Privacy (WEP)

WEP provides a basic level of security, preventing unauthorized access to the

network, and encrypting data transmitted between wireless clients and the access

point. WEP uses static shared keys (fixed-length hexadecimal or alphanumeric

strings) that are manually distributed to all clients that want to use the network.

Figure 4-23: Security

NOTE

You must first enable VAP interface 0 before you can enable other VAP interfaces.

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 290 291

Sin comentarios

Alvarion Wi^2 AP CLI Especificaciones Pagina 134