
WAN IP Interface Context
Wi² Controller CLI Reference Guide 99
pppoe auto-reconnect
Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200
pppoe auto-reconnect
The Controller will automatically attempt to reconnect if the connection is
lost.
no pppoe auto-reconnect
The Controller will not automatically attempt to reconnect if the connection
is lost.
pppoe mru
Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200
pppoe mru <bytes>
Specifies the maximum receive unit.
Changes to this parameter should only be made according to the
recommendations of your ISP. Incorrectly setting this parameter can reduce
the throughput of your Internet connection.
Parameters
<bytes> Maximum size (in bytes) of a PPPoE packet when
receiving. Range: 500 - 1500 bytes.
pppoe mtu
Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200
pppoe mtu <bytes>
Specifies the maximum transmit unit.
Changes to this parameter should only be made according to the
recommendations of your ISP. Incorrectly setting this parameter can reduce
the throughput of your Internet connection.
Parameters
<bytes> Maximum size (in bytes) of a PPPoE packet when
transmitting. Range: 500 - 1500 bytes.
pppoe unnumbered
Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200
pppoe unnumbered
Enable unnumbered mode.
no pppoe unnumbered
Disable unnumbered mode.
Comentarios a estos manuales