Alvarion Wi^2 AP CLI Especificaciones descargar pdf (Pagina 84)

58 Wi² Controller CLI Reference Guide

Chapter 2 - CLI Commands

no service controller primary

Become a secondary service controller.

service controller primary ip addr

Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200

service controller primary ip addr <ip address>

Configure a static ip address for the primary service controller.

service controller provisioning

Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200

service controller provisioning

Enable the Wi² AP provisioning system.

no service controller provisioning

Disable the Wi² AP provisioning system.

bridge priority

Supported on:

bridge priority <number>

Sets the bridge priority for the spanning tree.

The spanning tree uses the bridge ID to elect the root bridge and the

designated bridges. The bridge ID is built with the MAC address of the bridge

and the bridge priority. The first 2 most significant bytes are the bridge

priority and the next 6 bytes are the MAC address. To control which bridge

will become the root bridge, you can configure the bridge priority parameter

on the bridges. The root will be the bridge with the lowest bridge ID. The

Bridge priority has a valid range of 0 to 0xFFFF. The default value is the

middle value: 0x8000.

bridge protocol ieee

Supported on:

bridge protocol ieee

Enable the bridge spanning tree protocol to prevent undesirable loops from

occurring in the network that may result in decreased throughput.

no bridge protocol ieee

Disable the bridge spanning tree protocol.

bandwidth control internet-port

Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200

bandwidth control internet-port

Enables bandwidth control on the Internet port.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 211 212

Sin comentarios

Alvarion Wi^2 AP CLI Especificaciones Pagina 84