Alvarion Wi^2 AP CLI Especificaciones descargar pdf (Pagina 126)

100 Wi² Controller CLI Reference Guide

Chapter 2 - CLI Commands

This feature is useful when the Controller is connected to the Internet and

NAT is not being used. Instead of assigning two IP addresses to the

Controller, one to the Internet port and one to the LAN port, both ports can

share a single IP address. This is especially useful when a limited number of

IP addresses are available to you.

ip nat outside source static

Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200

ip nat outside source static (tcp|udp) <visible-port>

<internal-addr> <internal-port>

Adds a static NAT mapping which routes the specified incoming traffic to the

specified IP address on the internal network.

Parameters

tcp | udp Selects the protocol that the mapping will operate on.

<visible-port> The protocol port number that the incoming traffic

uses.

<internal addr> IP address of the device on the internal network that

traffic will be routed to.

<internal-port> The protocol port number that the incoming traffic will

be mapped to.

ip rip authentication key-chain

Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200

ip rip authentication key-chain <name>

Specifies a keyed MD5 chain.

no ip rip authentication key-chain

Do not use this Keyed MD5 chain.

ip rip authentication mode

Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200

ip rip authentication mode (md5 | text)

Select RIPv2 authentication mode.

no ip rip authentication mode

Use no RIPv2 authentication.

ip rip authentication string

Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200

ip rip authentication string <secret>

Sets the RIP shared password.

no ip rip authentication string

Clears the RIP shared password.

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 211 212

Sin comentarios

Alvarion Wi^2 AP CLI Especificaciones Pagina 126