
178 Wi² Controller CLI Reference Guide
Chapter 2 - CLI Commands
dot11 automatic transmit-power period
Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200
dot11 automatic transmit-power period (1h | 2h | 4h | 8h | 12h |
24h)
Sets the interval at which the transmit power setting is re-evaluated when
automatic power selection is enabled.
antenna bidirectionnal
Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200
antenna bidirectionnal (diversity | main | auxiliary)
Sets the antenna to transmit and receive on. Select diversity to transmit
and receive on both antennas.
Parameters
diversity In this mode both antennas are used to transmit and
receive. The Controller supports both transmit and
receive diversity.
main Transmit and receive on the main antenna only.
aux Transmit and receive on the aux antenna only.
autochannel skip
Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200
autochannel skip <chan>
Adds the specified channel to the list of channels that are not allowed to be
selected by the Auto Channel algorithm.
station distance
Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200
station distance (0km | 5km | 10km | 15km | 20km | 25km | 30km |
35km)
Fine tunes internal timeout settings to account for the distance that
wireless links span. For normal operation, the CNx is optimized for links of
less than 1 km.
This is a global setting that is useful when creating wireless links to remote
sites. However, it also applies to all wireless connection made with the radio,
not just for wireless links. Therefore, if you are also using the radio to serve
local wireless client stations, adjusting this setting may lower the
performance for clients with marginal signal strength or when interference
is present. (Essentially, it means that if a frame needs to be retransmitted it
will take longer before the actual retransmit takes place.)
Comentarios a estos manuales