
38 Wi² Controller CLI Reference Guide
Chapter 2 - CLI Commands
snmp-server allow
Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200
snmp-server allow <ip address>/<mask>
Adds a host to the list of IP address from which access to the SNMP interface
is permitted.
no snmp-server allow <ip address>/<mask>
Removes a host from the list of IP address from which access to the SNMP
interface is permitted.
Parameters
<address> IP address.
</mask> Subnet mask in CIDR format. Specifies the number of
bits in the mask.
snmp-server chassis-id
Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200
snmp-server chassis-id <name>
Specifies a name to identify the Controller. By default, this is set to the
serial number of the Controller.
no snmp-server chassis-id
Deletes the system name.
snmp-server contact
Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200
snmp-server contact <email>
Specifies contact information.
no snmp-server contact
Deletes contact information.
Parameters
<email> Email address.
snmp-server heartbeat period
Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200
snmp-server heartbeat period <seconds>
Sets the interval between sending heartbeat traps.
Parameters
<seconds> Heartbeat interval in seconds.
Comentarios a estos manuales